by FigDJ on 13 Nov 2017, 16:23
I assumed that the default maps allows you to control decks A and B.
Your 1st two controllers are set
Deck1=Player A= Channels 1 and 2
Deck2=Player B= Channels 3 and 4
you must set the MIDI channel for the additional decks to
Deck3=Player C= Channels 5 and 6
Deck2=Player D= Channels 7 and 8
Then you must take the default file make a copy and modify the copy as follows:
1. Take all deck commands for Player A
copy to a working editor blank file
2. Modify all commands listed for player A channel 1 to
Player C channel 5.
3. Modify all commands listed for player A channel 2 to
Player C channel 6.
4. Copy all the modified command and added to the end of the input mapping section of the copied file from default.
In your working file
5. Modify all commands listed for player C channel 5 to
Player D channel 7.
6. Modify all commands listed for player C channel 6 to
Player D channel 8.
7. Copy all the modified command and added to the end of the input mapping section of the copied file from default.
That should take care of all deck commands. FX and global commands will need some revision but that should get you started.