Any experience with Denon DN-MC6000 ?

[Support@MixVibes]

A little issue with the 14 bits feed... try to uncheck the 14bits box into the MIDI preferences.
If it work for you we'll update the mapping.

[DJ_Promille]

Thanks for the reply. I unchecked the 14 bit box and know the faders are working correctly

[sakaana]

Sorry for bringing up that old thread.
Getting my MC6000 today. Please tell me that timecode vinyl will work

[Jim B]

Please tell me that timecode vinyl will work

You can use 2 turntables and play regular vinyls in analog mixer mode, But looking on other forums it seems the Denon DN-MC6000 sound card does not support inputs for timecodes (but I could be wrong)

[Hannes]

I´m not shure either.

Personally i only had trouble with Denon´s Asio driver and also different forums from other companies are full of bad reports....

[Support@MixVibes]

It supposed to work but a bit akward to setup if I remember well...

[sakaana]

Checked the Denon forum and some other places and it looks like i can`t do (Cross) timecode vinyl with the MC6000. Any help is very welcome, even if it would be some "dirty" way. Please PM me if you can help!

If not that unit will go back even when i love it so much cause it`s well build...

[Blackbrook]

Bad, badder worse workaround: Using another audio interface for timecode while the Controller ist "just" for controlling? I know, I know,...but if you love the controller and it is really unable to detect timecode this might be a chance to use it with timecodes.

[Hannes]

Checked the Denon forum and some other places and it looks like i can`t do (Cross) timecode vinyl with the MC6000. Any help is very welcome, even if it would be some "dirty" way. Please PM me if you can help!

If not that unit will go back even when i love it so much cause it`s well build...

I just checked the vdj forum as well, people there say it doesnt work...
the inputs only allow for routing within the dmc, but the signal wont be sent to the PC, that sucks

[Support@MixVibes]

Sorry for the misinformation, it is the new to come firmware of the VCI400 that allow this.
And the weird guy to setup is the VMS4.