Page 1 of 1

Cross DJ4 MIDI Problem

PostPosted: 13 Jul 2019, 21:10
by laconic1102
Hi, since yesterday i update to Cross4. I use a Pioneer SB2 and a AKAI MPD218. Everything is ok with the SB2 but not with the AKAI. In Cross 3 i use the AKAI for the Filters and Effects. In Cross4 it is not possible. I create a new controller in the list and teach the knobs and pads in MIDI section. If i teach a knob for the FX (Filter Delay for example), the line from the knob turns a little bit and stay after few seconds in only one position. I could turn the knob on the AKAI and see that somthing happend at Cross but it is not the full range of the filter, only one position or the line tremble...
Via MIDI learn, is the same.

I hope you could help me! Best regards, Sven

Re: Cross DJ4 MIDI Problem

PostPosted: 17 Aug 2019, 11:03
by laconic1102
no answer to my question...Administrator? I´m sad about this!
I buy a new product with no support. Is easier to make money with the product...

Re: Cross DJ4 MIDI Problem

PostPosted: 19 Aug 2019, 14:15
by RoJeC
Moved your topic to the MIDI forum.

Not sure if it helps, but the MIDI expert usually checks this forum faster. However he also has some questions asked to MV regarding v4 features for MIDI.