Page 1 of 1
Cross DJ4 MIDI Problem
Posted:
13 Jul 2019, 22:10by laconic1102
Hi, since yesterday i update to Cross4. I use a Pioneer SB2 and a AKAI MPD218. Everything is ok with the SB2 but not with the AKAI. In Cross 3 i use the AKAI for the Filters and Effects. In Cross4 it is not possible. I create a new controller in the list and teach the knobs and pads in MIDI section. If i teach a knob for the FX (Filter Delay for example), the line from the knob turns a little bit and stay after few seconds in only one position. I could turn the knob on the AKAI and see that somthing happend at Cross but it is not the full range of the filter, only one position or the line tremble...
Via MIDI learn, is the same.
I hope you could help me! Best regards, Sven
Re: Cross DJ4 MIDI Problem
Posted:
17 Aug 2019, 12:03by laconic1102
no answer to my question...Administrator? I´m sad about this!
I buy a new product with no support. Is easier to make money with the product...
Re: Cross DJ4 MIDI Problem
Posted:
19 Aug 2019, 15:15by RoJeC
Moved your topic to the MIDI forum.
Not sure if it helps, but the MIDI expert usually checks this forum faster. However he also has some questions asked to MV regarding v4 features for MIDI.
Re: Cross DJ4 MIDI Problem
Posted:
12 Nov 2020, 00:34by DJSqualeMusic
i thought this was the MIDI forum, and i thought to talk to support they want you to send in a request for support or an email...this is just users i thought
Re: Cross DJ4 MIDI Problem
Posted:
14 Nov 2020, 15:33by FigDJ
laconic1102 wrote:Hi, since yesterday i update to Cross4. I use a Pioneer SB2 and a AKAI MPD218. Everything is ok with the SB2 but not with the AKAI. In Cross 3 i use the AKAI for the Filters and Effects. In Cross4 it is not possible. I create a new controller in the list and teach the knobs and pads in MIDI section. If i teach a knob for the FX (Filter Delay for example), the line from the knob turns a little bit and stay after few seconds in only one position. I could turn the knob on the AKAI and see that somthing happend at Cross but it is not the full range of the filter, only one position or the line tremble...
Via MIDI learn, is the same.
I hope you could help me! Best regards, Sven
Please post your old Cross 3.x map and the new one for Cross 4.x
I suspect that you have to include a 14 bit MIDI map command line. need the files to verify.