Re: light dj-tech dragon two

This mapping has changes only to "kill" and "loop on / off". I tried to change the "key semitones" but does not work as I would like.
I use "key semitones" as you have established...

Thanks
Closed forum. You can only use it as a source of information about MixVibes software
http://forum.mixvibes.com/
ROZE61 wrote:Hi,
I made a drawing for my changes.
Thank you again for what you did ...
ROZE61 wrote:2) s1/s2 and s3/s4 = works but no lights (is not a problem)
So you don't want any loop indicators using the LED for the encoder.ROZE61 wrote:3) loop on/off = works, but light up also encoder led (killbass)when you insert loop on/off, ....
ROZE61 wrote:the "killbass encoder" has 3 LEDs in less.
ROZE61 wrote:4) killbass= works with full leds but have a problem with mid and high:
I push the killbass and then move high/mid knob > high and mid mulfunctioning, they have gone mad...
FigDJ wrote:ROZE61 wrote:Please explain better.ROZE61 wrote:4) killbass= works with full leds but have a problem with mid and high:
I push the killbass and then move high/mid knob > high and mid mulfunctioning, they have gone mad...
No changes were made to those but will check for errors.
FigDJ wrote:So you don't want any loop indicators using the LED for the encoder.ROZE61 wrote:3) loop on/off = works, but light up also encoder led (killbass)when you insert loop on/off, ....ROZE61 wrote:the "killbass encoder" has 3 LEDs in less.