ashp wrote:I'm using Numark Mixtrack Quad.
Here's the mapping file so far: -
MixTrack Quad(Numark).mappings.txt
60% setup
3 Master knobs work
eq works
browser knob works
browser leds do not work
faders work
pfls work sticky deck C & D PFL led need sorting
platters work LED's needs tweaking
Sync, cue, play and stutter work but need tweaking
keylock+pitch range not mapped
samples work incl. leds
hotcues work incl. leds but you cannot delete (gets stuck)
FX works needs tweaking but no led
autoloop needs mapping
slip mode needs mapping
roll mode needs mapping
loop works but leds need mapping
We should work one problem at a time. Just after a quick glance I noticed the following regarding the modifiers.
Shift= Shift logic 1 ML1
Currently mapped as follows:
DECK A-->parameter 61--> channel 2
DECK B-->parameter 62--> channel 3
DECK C-->parameter 61--> channel 4
DECK D-->parameter 61--> channel 5
The correct map is
DECK A-->parameter 61--> channel 1
DECK B-->parameter 62--> channel 2
DECK C-->parameter 61--> channel 3
DECK D-->parameter 61--> channel 4
HOTCUE DELETE MODE= SHift logic 2 ML2
(only Active if ML1 is active)
Currently mapped as follows:
DECK A-->parameter 70--> channel 2
DECK B-->parameter 70--> channel 3
DECK C-->parameter 70--> channel 4
DECK D-->parameter 70--> channel 5
The correct map is
DECK A-->parameter 70--> channel 1
DECK B-->parameter 70--> channel 2
DECK C-->parameter 70--> channel 3
DECK D-->parameter 70--> channel 4
Make those modifications to a copy of your map and see if the logic switching is now working for you. We can then start working on a 100% solution.
Hope it works (finger crossed)