Page 1 of 1

MIDI is mapped however.......

PostPosted: 15 May 2014, 21:54
by show-spect
I Have no sound. I'm using and Akai LPD8 controller. I see on screen where my pads are mapped for sampler A. however I have no sound. Any suggestions for a solution would be greatly appreciated.

Re: MIDI is mapped however.......

PostPosted: 15 May 2014, 22:37
by RoJeC
MIDI mapping is independent of audio routing. (don't know if this good or bad news for you).

Could you post a capture of your Audio tab in preferences to avoid misunderstanding of the routing you setup.

Did you install and select the audio driver for the controller; if possible the ASIO driver for the device.

Re: MIDI is mapped however.......

PostPosted: 16 May 2014, 03:28
by daniel clark
RoJeC wrote:MIDI mapping is independent of audio routing. (don't know if this good or bad news for you).


Did you install and select the audio driver for the controller; if possible the ASIO driver for the device.


:idea: check audio config to make shure its correct ,,
check MIDI map selected to check operation of controller
:cool: