Re: Behringer CMD DC-1 Output help
Posted: 06 Feb 2014, 06:57
I have made some progress today. I managed to get feedback on the LED rings working for FX select and FX input select. Since both of these commands have specific value limitations I mapped each separate value to a specific LED in the ring.
I have been unsuccessful using %, the last LED in the list always stays on and all the others are dim and randomly flicker (I suspect this may be due to the LED Ring being one CC with each LED being a different value, instead of separate CC/Note value for each LED).
Mapping each value seperately only seems to work on commands with specific value limitations. When I tried to map feedback for the FX amount and depth (which have a full 0-127 range) in the same way, none of the LEDs would come on.
Also I discovered that the LED rings repeat in values 33-47 and 48-63, but their behavior seems to be identical to the lower range so this doesn't seem to help.
Hope this all makes sense and is some help!
I have been unsuccessful using %, the last LED in the list always stays on and all the others are dim and randomly flicker (I suspect this may be due to the LED Ring being one CC with each LED being a different value, instead of separate CC/Note value for each LED).
Mapping each value seperately only seems to work on commands with specific value limitations. When I tried to map feedback for the FX amount and depth (which have a full 0-127 range) in the same way, none of the LEDs would come on.
Also I discovered that the LED rings repeat in values 33-47 and 48-63, but their behavior seems to be identical to the lower range so this doesn't seem to help.
Hope this all makes sense and is some help!