MIXVIBES Dj Community old forum

need help in configuring Cross 1.6...

the current set-up i have is laptop, U-Mix Control Pro, 1 turntable..

there's 2 kinds of setup i wanna know how to use:
1)using Cross with U-Mix Control Pro alone..when i plug in U-Mix Control Pro, the cue/play/sync buttons doesn't work..

2)using Cross with one side timecode vinyl + one side U-Mix Control Pro player.

i cant find any tips on support page on this and hope any of you out there have already know the cure.
thanks

Go to the Cross preferences and check the Vinyl/CD tab where you can choose which deck should be controlled via timecode. If you leave both decks unmarked you can use Cross with your U-Mix Control Pro as usual.

Cheers,

Steve

damnn!..haha...thanks.i was finding the word player but line in and phono is the only option..ive mandle with the preference tabs for quite sometime and realised that..

what ive noticed is that to use:

control vinyls,cds etc. - put input to 1/2 or 3/4.

control by controller itself - put input to none!.

thanks