MIXVIBES Dj Community old forum

Hello Ijust bought mixvibes DVS Ultimate yesterday i did all the work to setup the programme and the soundcard ( U-Mix 44 ) , i have to cdj - 400 pionner and i have a serious problem withe the calibration ome the cds nad always the programme is in 0% in the timecode area .... what i'm not doing well so i can not fix the programme?

Perhaps, you have time stretch mode enable on your CDJs. If this is the case, you have just to disable this fonction.

Cheers

how i disable that in the cds?

Just push the Master Tempo button. If it's red it's enabled and if it's black, it's disabled.

Cheers

Hello, Please fill out your serials in order to get support!
Here is the procedure:
viewtopic.php?f=268&t=18922

i did that but nothing i believe that im not doing something good with the installation if you can saw me the good way to doit from the beginning maybe it will possible to fix this

Please PM me your serials so that i check them out!

[EDITED BY: community@mixvibes]

JXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Please do not provide serials on the Forum!

mikedrive wrote:[EDITED BY: community@mixvibes]

JXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

Please do not provide serials on the Forum!

Hello,

Serials are valid, you'll need to try registering again later!

ok listen i'm from greece and my english is not very well so tell me all the way from the begging to start an installation to this programme ... and allready register to the community what i have to do again