MIXVIBES Dj Community old forum

When I plug my headphones into the u46mk2 I do get sound and I followed the instructions but I can't get sound out of my mixer. I'm not sure what I am doing wrong. Have out 1/2 of u46 into line 1 of mixer (mixer is dn-x300) have out of 3/4 of u46 into line 2 of mixer. Using Numark ttx turntables. again can hear sound perfectly and scratch record out of u46 but it's like my mixer is a paper weight. lights come on on the mixer but Cross fader doesn't work neither does the channel volumes. Someone plz help.

A-Riz

Hi,
do you have Cross set to "external Mixer" in the audio-prefs?
it basically can only be a routing problem if you already have sound via the headphone out.
cheers
J

Risalation wrote:When I plug my headphones into the u46mk2 I do get sound and I followed the instructions but I can't get sound out of my mixer. I'm not sure what I am doing wrong. Have out 1/2 of u46 into line 1 of mixer (mixer is dn-x300) have out of 3/4 of u46 into line 2 of mixer. Using Numark ttx turntables. again can hear sound perfectly and scratch record out of u46 but it's like my mixer is a paper weight. lights come on on the mixer but Cross fader doesn't work neither does the channel volumes. Someone plz help.

A-Riz

Hello, what software are you using, please fill out your serials in order to be able to help you out. Here is a link explaining how to fill out your serials.

viewtopic.php?f=268&t=18922

Sorry bout the delay had to finish up finals...is the serial the authentication code I had to enter when I first installed my software?

Yes, that´s the serial.
regards
J

Like a dumbass I have lost my serial key...probably somewhere in my junkie room...can I obtain it from within the software itself?

Risalation wrote:Like a dumbass I have lost my serial key...probably somewhere in my junkie room...can I obtain it from within the software itself?

Unfortunately no, you have to find it in your room. The serial is the key to all updates and support so it is VERY important.

Cheers,

Steve

Ok so I made a mistake...had the inputs on my mixer set to line rather than phono so no mixer is fine and can hear music out of speakers now...hear a humming or buzzing kind of sound probably need to make a few adjustments though...funny thing is I could have sworn that I saw a tutorial video that said set mixer to line since it was a line level signal

Ok, so is it working now, or are you still having your issue? By the way you need to find your license keys as this will allow you to have support if you ever need it!

No issue is resolved mixer and everything is working fine now. Just need to make adjustments to my setup and everything will be fine I'm sure...ill find the key after I clean my place