MIXVIBES Dj Community old forum

Hello!

i'm haveing problem with timecode..
all works fine with Cross 1.5 Demo, but no luck with Vfx... signal is 100% but will not play media... tried with Pioneer 100, 400 1000, 2000...

any suddestions?

Aivar

Hello,

maybee a silly question but have you enabled the Vinyl Mode? and some more details about what you have done could be also helpful to get a better picture of what could going wrong.

regards
Christian

Did you engage vinyl on the gui ?

christiankoopmann wrote:Hello,

maybee a silly question but have you enabled the Vinyl Mode? and some more details about what you have done could be also helpful to get a better picture of what could going wrong.

regards
Christian

defenetly forgot to press Vinyl Mode...
There's only one problem left... everything is now okay with player 2, but when i press Vinyl mode on player 1, playback stops immeditly...
no matter does controller is off or on.. it's from software...
now, how do i fix this?
just made clean install and problem remains...

thank You all for quick help allready!

Aivar

If playback stop then it doesn't receive proper timecode signal.
Publish your setting screens or a config report.

Support@MixVibes wrote:If playback stop then it doesn't receive proper timecode signal.
Publish your setting screens or a config report.

No, timecode is 100%... i must correct my statement it's not software.. when i connect Controller, then when i push Vinyl Mode it stops and resumes play when i deactivate Vinyl Mode.. With software only there is not such problem.. So soft is good
is there MIDI file corrupted or something else?
i used for this simple settings, infernal mixer, no timecode.. Same thing..

The controller send a touch if it stops as soon as you are in vinyl mode.
What happen if you touch the top of the wheel ?

Support@MixVibes wrote:The controller send a touch if it stops as soon as you are in vinyl mode.
What happen if you touch the top of the wheel ?

if i just touch, nothing happens, if i try to spin it, it tries to hold it on current place.. i mean it is possible to spin it (not with ease), but result is poor. when i press Play button, it won't play until i release Vinyl Mode...

That what I said, the controller is sending a constant "touch" command : defective unit.

Support@MixVibes wrote:That what I said, the controller is sending a constant "touch" command : defective unit.

ok, sry..
what should i do?