MIXVIBES Dj Community old forum

Sup!
I'm having some setup problems with my Numark IDJ3 Mixvibes Cross 1.3.4

I'm on PC connected through USB.

I cannot seem to separate the master to my PC speakers and the Cue to my headphone jack on the Numark DJ device.

The problem is, when I select

IDJ3 ASIO Driver, the only available outpits in Output 1,2, and 3 is "Out 1/Out 2"

I can change my drivers to the speakers, or the headphones, but I cannot select them as separate output devices.

I downloaded ASIO4ALL v2 and when I select that driver, I Can config it to recognize both the PC speakers, and the headphones jack on my Numark DJ device, as well as any additional ports on my PC I wish to set up.

I can also set my PC speakers as one output, and the Numark speakers as a 2nd out put, but from here I cannot get the audio to split, one to the cue and one to the master, or headphones/PC in this case.

I'm using Dual Stereo as the output settings.

I don't understand why I can't get the IDJ3 ASIO Driver to detect anything but "Out 1/Out 2", well anyway, been messing with this for like 6 hours and my head hurts! Helpz!

Just installed one (it's been a long time) and it was ok out of the box.


If you can't setup yours like this, please see with Numark, there must be a issue with the soundcard and/or drivers.

Hello,

and when you register your software here you can also download the newer version of Cross. As I know is the 1.3.4 an older version. The current is I think 1.5.2.

regards
Christian

IDJ3 is a LE version and then can't be updated.

If I can get my settings to look like that picture above, how do I get output 1/2 to be my PC speakers, and output 3/4 to be the idj3 headphones jack?

Check out this video, can skip the part about the headphones jack not fitting, I'm past that lol

http://www.youtube.com/watch?v=RQuTH7r_P5w

I can set mine up exactly like his, connecting to PC via USB.

If I switch to a/b on the Cue Source, I get no audio through my PC speakers or my Headphones. If I switch over to Master, I get audio from both a and b in my headphones.

I found other threads with people describing that exact issue only unresolved. I hope it's just a setting somewhere, but I highly recommend that if this product is still on the market that they write a config guide for the audio settings. I'm frickin exhausted of trying to make this thing work!

Try with the Cross demo to see if it work.

If it work then you need to upgrade to have a fix, if it doesn't then you have a driver/hardware issue.