MIXVIBES Dj Community old forum

hi, i'm wondering if my soundcard is ok for using timecode in mixvibes?
name soundcard: infrasonic quartet
its a pci card with 2 line in - 2line out

I don't really about the card, support will be along later and should have a better knowledge than me.

But if you want to control both decks then you need a 4 input/4 output ASIO. Soumdcard.

th3llc wrote:hi, i'm wondering if my soundcard is ok for using timecode in mixvibes?
name soundcard: infrasonic quartet
its a pci card with 2 line in - 2line out

If 2 line in - 2 line out means two pairs of RCA for in- & output you have exactly the in- and outputs you need. There is only a last question left: If you are using turbtables you need a phono preamp to amplify the incoming low level signal. If you are using CD Players you should be ready to rock

Greetings,

Steve

i'm using cd-players, the input and output are with jacks(balenced)
so i use the cable '5mm-jack-balenced to rca(red and black/white)
i'll see what i can do with it, i probably just gonna buy the whole Cross Pack.
thx for reactions!

Just FYI, Phono preamps are only needed if you wanna be able to play real vinyls (no TC) with a high quality (software phono preamps are always worst than hardware ones).
For TC vinyl control, no phono preamp is needed but good preamps (not phono, only gain) is a plus!

Cheers,