Mixvibes Dj Community old forum

I have problem where after about 5 minutes of playing the scratch button on IDJ3 stops working. But when I shut down Cross and put it on again everything is ok. Is this IDJ3 or software?

Do you mean that you cannot switch to and from scratch mode when this happen ?

Support@MixVibes wrote:Do you mean that you cannot switch to and from scratch mode when this happen ?

Correct

Never seen or heard this before, I'll check with an IDJ3 if I can reproduce this.
Nothing in 30 minutes.

I think I figured out the problem. I was using an older sound system at the time and I guess it was too close and causing problems because when I hooked up my IDJ3 to my system (which is newer) I had no problems.

Hey, i just recently got the Numark idj3 with mixvibes, when i go to play a song it only goes through the headphones and not through my computer which is a mac version 10.5.8. Also when i go to change the audio setting i put bulit in microphone it then comes out through the computer and when i plug in the headphones they dont work..

please help its really frustrating!

Did you install the provided driver ? then restart the computer ?
It should work out of the box if you did so.

yes i did this multiple times im using mac 10.5.8 i go to mixvibes and when i originally play a song it doesnt come out of the speakers but when i plug my headphones it comes out.. Then i go to audio setting change it to ''Built in Microphone" and it comes out of the speakers but not through the headphones...

please help. I'm upset.

i use idj3 with mixvibes and it messes up when i try to scratch. for example im playing deck A and i start to scratch with deck B, deck A starts to skip and deck B is late and te scratch sounds bad. why and how does this happen??? please helpp!!!

Latency et computer performance I guess...