Page 1 of 1
IDJ3 using Cross 1.3.4
Posted:
13 Sep 2010, 18:33
by DJ_D
I have problem where after about 5 minutes of playing the scratch button on IDJ3 stops working. But when I shut down Cross and put it on again everything is ok. Is this IDJ3 or software?
Re: IDJ3 using Cross 1.3.4
Posted:
13 Sep 2010, 18:46
by Support@MixVibes
Do you mean that you cannot switch to and from scratch mode when this happen ?
Re: IDJ3 using Cross 1.3.4
Posted:
13 Sep 2010, 22:06
by DJ_D
Support@MixVibes wrote:Do you mean that you cannot switch to and from scratch mode when this happen ?
Correct
Re: IDJ3 using Cross 1.3.4
Posted:
14 Sep 2010, 11:20
by Support@MixVibes
Never seen or heard this before, I'll check with an IDJ3 if I can reproduce this.
Nothing in 30 minutes.
Re: IDJ3 using Cross 1.3.4
Posted:
15 Sep 2010, 01:25
by DJ_D
I think I figured out the problem. I was using an older sound system at the time and I guess it was too close and causing problems because when I hooked up my IDJ3 to my system (which is newer) I had no problems.
Re: IDJ3 using Cross 1.3.4
Posted:
16 Sep 2010, 02:19
by djchrisbenz
Hey, i just recently got the Numark idj3 with mixvibes, when i go to play a song it only goes through the headphones and not through my computer which is a mac version 10.5.8. Also when i go to change the audio setting i put bulit in microphone it then comes out through the computer and when i plug in the headphones they dont work..
please help its really frustrating!
Re: IDJ3 using Cross 1.3.4
Posted:
16 Sep 2010, 11:14
by Support@MixVibes
Did you install the provided driver ? then restart the computer ?
It should work out of the box if you did so.
Re: IDJ3 using Cross 1.3.4
Posted:
16 Sep 2010, 22:06
by djchrisbenz
yes i did this multiple times im using mac 10.5.8 i go to mixvibes and when i originally play a song it doesnt come out of the speakers but when i plug my headphones it comes out.. Then i go to audio setting change it to ''Built in Microphone" and it comes out of the speakers but not through the headphones...
please help. I'm upset.
Re: IDJ3 using Cross 1.3.4
Posted:
19 Sep 2010, 18:30
by dj <yourname>
i use idj3 with mixvibes and it messes up when i try to scratch. for example im playing deck A and i start to scratch with deck B, deck A starts to skip and deck B is late and te scratch sounds bad. why and how does this happen??? please helpp!!!
Re: IDJ3 using Cross 1.3.4
Posted:
20 Sep 2010, 11:52
by Support@MixVibes
Latency et computer performance I guess...