Cross not recognizing input signal
Posted: 26 Apr 2010, 00:12Cross 1.3.2
u46mk2 sound card
Audio technica at-lp120 direct drive turntables
Numark m3 mixer
mac osx
Often times I have to restart Cross about 10-15 times before it recognizes that the vinyl is spinning/recognize that there is an input signal. If I go into preferences it tells me there's no input signal. But then once in a while I will boot up Cross with the records spinning already and it'll recognize them right away.
Very frustrating as it happens very often.
Any idea what's going on here?
u46mk2 sound card
Audio technica at-lp120 direct drive turntables
Numark m3 mixer
mac osx
Often times I have to restart Cross about 10-15 times before it recognizes that the vinyl is spinning/recognize that there is an input signal. If I go into preferences it tells me there's no input signal. But then once in a while I will boot up Cross with the records spinning already and it'll recognize them right away.
Very frustrating as it happens very often.
Any idea what's going on here?
