MIXVIBES Dj Community old forum

Hi guys!
I have a problem with a U-Mix44 MixVibes DVS set. The system will be controlled by the CD. However, in Absolute mode (and other modes) the program does not respond to cue on the CD player, track just goes further and do not return to the cue point. The best part is that the calibration tab shows 0% quality time code, but normal play and scratch work without any problems. I checked two different cards U-Mix44, and still the same. Asio4ll driver. Operating System - Vista ... I tried all I know know ... Any ideas?
P.S. Config report soon

Hi sylvester. please post a config report.
best regards. marxon

Try this : http://mixvibes.com/support/?p=815&lang=en

Do what FaM0uS says. It's a simple case where the input levels are too high, and as such are being clipped. That's why the timecode appears to work mostly normally, but has 0% quality (all of the extra 'time' information is lost in the clipping. Don't forget CD players have a very high output level, and should not generally be amplified

yesm it works! I adjust level from windows sound setup and now MV calibration show 100%

Thanks!