Problems mit MixVibes
Posted: 29 Dec 2009, 19:26......................................
MIXVIBES Dj Community old forum
Closed forum. You can only use it as a source of information about MixVibes software
http://forum.mixvibes.com/
Problems mit MixVibes
Page 1 of 1
Posted: 29 Dec 2009, 19:26Re: Problems mit MixVibes
Posted: 29 Dec 2009, 19:29...........................
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 00:18welcome to mixvibes d.j hudu
you have to put your Cross software number in your profile
(click user control panel , go profile)
after you have done that you can go to the download part off the forum & get new Cross update 1.3 + goody's + support
you have to put your Cross software number in your profile
(click user control panel , go profile)
after you have done that you can go to the download part off the forum & get new Cross update 1.3 + goody's + support
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 02:11Hello,
Thank you for your fast answer, i downloaded Cross 1.3.1 .
But there is the same Problem...
The Interface does not connect with one TT.
The quality of the one which connected is perfect!
Thank you for your fast answer, i downloaded Cross 1.3.1 .
But there is the same Problem...
The Interface does not connect with one TT.
The quality of the one which connected is perfect!
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 02:47Hi DJ Hudu. Welcome to the MV forums
*Check your Needle cartridge connecters. Unscrew them, blow in the socket, and 'jiggle' them around.
*What is the % of timecode are your getting when your are in 'preferences>vinyl' calibration? (on the working deck, and the not working one?)
*Try plugging the working TT into the channel that seems to be NOT working. If that is ok, then it is a problem with your TT/needles/cables/ground wires.
*Are the outputs from the u46 plugged into 'line ' inputs on your mixer?
Cheers
*Check your Needle cartridge connecters. Unscrew them, blow in the socket, and 'jiggle' them around.
*What is the % of timecode are your getting when your are in 'preferences>vinyl' calibration? (on the working deck, and the not working one?)
*Try plugging the working TT into the channel that seems to be NOT working. If that is ok, then it is a problem with your TT/needles/cables/ground wires.
*Are the outputs from the u46 plugged into 'line ' inputs on your mixer?
Cheers
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 13:14the problem is probably the low power on Macbook USB ports. Some ports provide more power than others. I recommend you buy a 9V power supply for your U46 if this problem persists...
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 17:15I thought I read that the U46mk2 had to always be plugged in the same USB port. Was that just for DVS or is it also for Cross? Could it be the problem?
Re: Problems mit MixVibes
Posted: 30 Dec 2009, 17:48on a PC yes