Important notice : Cross Pack Vinyl users

[polocorp]

please make sure you switch your U46 to line and not phono.

New versions (from Cross 1.3.0) prefer the line signal to avoid pre-amp modifications.

Moreover, you do not need to switch to phono even when you play real records in bypass mode. Cross now takes care of emulating the RIAA pre amplification

[Blackbrook]

Thanks for this input! Will test it immediately! Thanks Paul!

[dviason]

please make sure you switch your U46 to line and not phono.

New versions (from Cross 1.3.0) prefer the line signal to avoid pre-amp modifications, use your phono switch only when you want to bypass the software and play vinyl.

hi polocorp
thx for the info but when i switch to phono to play real vinyl i have an horrible noise comin', d'u know how to avoid it ?

[Support@MixVibes]

You don't have to switch to phono, it's all handled by the software.

[polocorp]

my bad... i just edited my post

FYI : you do not need to switch to phono even when you play real records in bypass mode. Cross now takes care of emulating the RIAA preamplification

[Stealthii]

I disagree. Upon testing the RIAA filter built into Cross the sound is horribly flat. I've posted about this issue here. Until then I will continue to use a phono preamp until the issue is resolved.

[djeksotik]

i have stanton str8-80 tuntables, which have a phono/line swith under the platter. now, would it be better for mixvibes Cross if i swithed my TT-s to line? how would this affect bypassing to play regular vinyl?

[hemskoc]

i have stanton str8-80 tuntables, which have a phono/line swith under the platter. now, would it be better for mixvibes Cross if i swithed my TT-s to line? how would this affect bypassing to play regular vinyl?

i have str8-100's. Leave it on Phono output.
Cheers

[djeksotik]

If i swith my U46 to "line", i hear no sound.

?

[Support@MixVibes]

You shouldn't

You don't have to switch to phono, it's all handled by the software.

- put the soundcard on line
- install 1.3.2
and if you need to use true vinyls just swith from 'player' to 'line_in' with the sources button of the gui.

There is nothing simplier !