MIXVIBES Dj Community old forum

Hi all,

I installed my DVS Producer pro and hooked up a bcd3000
Only when i press buttons on the bcd3000 it doesnt always respond, sometimes i need to press twice (very anoying)

Can i solve this:?

Greetz
Gerd

Hi Gerd,

Hope this is not a hardware issue...

What MIDI mapping do you use?

[BEHRINGER BCD 3000] MixVibes 7

i tested some more, i always have to hit twice

Thanks gerdnb. Can someone try on his side?

Hi,
It sounds like a hardware issue... To check that, show the 'Info bar' [View > Info] and check that a MIDI message is well send when you hit the button. If not, the problem is hardware.

its responding good on MIDI commands

if i hit play on deck 1, it switches from
midi1-ch1 #90 12 0 (NOTEOFF 18 0) Command=
to
midi1-ch1 #90 12 7f (NOTEOFF 18 127) Command=PLAYPAUSE

and back

so its not a hardward problem
the program only changes on the filled command
i think line1 should be:

midi1-ch1 #90 12 1 (NOTEOFF 18 1) Command=PLAYPAUSE

If you use the MIDI files present in the dowload center, you absolutely need to use the last MV7 update: 7.218.
- Install the last update.
- Download the MIDI files from the download center.
- Copy them in the MIDI directory (C:\Program Files\MixVibesProducer\MIDI).
- Run MixVibes.

Then it should work.

Im running 7.218 and i downloaded the latest MIDI files.
But it doesnt work.

Do i have the wrong MIDI file?
Or is there a option somewhere that could cause this?

For some reason im also getting this error at startup.
MIDI driver BCD3000 not found.

My bcd3000 MIDI drivers are present do.

mm i dig into this, seems that the program has a problem reading the downloaded MIDI file

--------------------------------

solved it partly.

When i put the bcd3000 in standard mode it seems to work ok, but no leds turn on/off

When i put it in advanced, it work, but i have to click double.
Can i manualy add MIDI rx for leds?

I used an older version of the MIDI file to get it working, the newest doesnt work for me.

You need to use standard mode, I have the bcd2000 and the same thing, advanced mode makes all the buttons work as togle switches and the LED's show on/off for the togles in this mode. You can aways add the MIDI commands yourself to send the notes that turn on/off the LED's in standard mode but the default MIDI maps in Mixvibes do not send MIDI they just recieve them..