Page 1 of 1

Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 04 Jun 2009, 06:00
by DJ911
My system is Dell D520 With 4 GB Ram Windows XP Home Edition.

Problem: My Behringer BCD3000 Controller will not work with

Mixvibes Producer 7. There is no TIME CODE VINYL DETECTION.

See picture attached.

Re: Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 04 Jun 2009, 07:32
by abitmessie
Hi

I dont belive that the audio is routed from the input of the BCD3000 to the PC so the timecode will not be passed into MV hence you issue

I sugesst you look at using the BCD as a MIDI controller

From my understanding the BCD as line and phone input to allow you to CD players and turntable to be connected aswell as controlling software via MIDI

hope this helps

Re: Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 04 Jun 2009, 07:33
by abitmessie

Re: Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 05 Jun 2009, 11:22
by djegun
Hi I tested a bcd3000 input with a turntable and it worked. So double check everything (connections...) and send a config report.

Re: Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 06 Jun 2009, 04:03
by DJ911
djegun wrote:Hi I tested a bcd3000 input with a turntable and it worked. So double check everything (connections...) and send a config report.


Tell me how to send config report, eventhough I have checked and rechecked connections, still No Time Code signal through BCD3000
Whats up?

Re: Mixvibes Pro 7 Behringer BCD 3000 Crash No Time Code Signal

PostPosted: 06 Jun 2009, 10:25
by UncleVibes
On the header of this topic...

- Post a config report if you are having a technical issue (preferences > config report). make sure both needles are on the record anf that your pitch is at 0.

copy & paste on the forum the config report