MIXVIBES Dj Community old forum

Posted: **01 May 2009, 17:57**

OK here is my new problem. I can play music thru both channels of my analog mixer using my MIXVibe software players. I can not use the jog wheel on the software the control playback. My analog mixer and CD players are hooked up thru MAYA 44. When I try to use the jog wheel on my CD players I only get the test signal coming thru over top of the music playing from the MixVibes. CD 2 unit still plays thru channel 1 when I use my external CD players.

Please Help! :frown:

Wendell

Posted: **04 May 2009, 20:18**

Is there anyone out there that can help me with my problem?

Posted: **04 May 2009, 20:48**

Mute the passthrough volumes of the unput lines, this stops the timecode from being heard.

while you use timecode to control players the gui jog wheel wont do anything... you would have to stop the timecode first.

regards,
Bryan

Posted: **06 May 2009, 06:30**

Hi Bryan,

I have stopped the timecode signal but I still can not control the music from my mixer using the jogwheel or from MixVibes. Please check my comfig. report.

Thanks,
Wendell

Config Report:

Posted: **06 May 2009, 09:39**

MixVibes DVS version=6.370 DLL

Which version of mixvibes do you use? There isn't any more support for versions 6.
If you own this version introduce its serial in your forum profile & then download for free version 7 DVS.

MIXVIBES Dj Community old forum

Sound card set up problems

Sound card set up problems

Re: Sound card set up problems

Re: Sound card set up problems

Re: Sound card set up problems

Re: Sound card set up problems