MIXVIBES Dj Community old forum

Hi, i have a FSOpen sound card running ok (reason, ableton live, etc) on a mac. i have bougth the mixvibes original and when i connect the FS it dont recognize the inputs, all are inactive. what can i do? thank you!

Hello !

check this [EN] Quick Start Guide Cross
i think it may help !


tip: You can click the inactive inputs (red) to make them active (green).

choof wrote:Hi, i have a FSOpen sound card running ok (reason, ableton live, etc) on a mac. i have bougth the mixvibes original and when i connect the FS it dont recognize the inputs, all are inactive. what can i do? thank you!

make sure the final scratch drivers are installed properly.

use the install configuration wizard within mixvibes to set up the sound card. while doing that you can see if all inputs & outputs are recognized by mixvibes.

I use the scratch amp soundcard (that's the correct name of the FS Open sound card) & it works superbly.

Macgyver wrote:use the install configuration wizard within mixvibes to set up the sound card. while doing that you can see if all inputs & outputs are recognized by mixvibes.

Thanx Macgyver but there's no install configuration wizard in Cross
(not talking about MV7 !)

But if the inputs/outputs are displayed in the Cross audio preferences, it means they are recognized. You just need to click on the red ones to activates them if needed.

Choof, did you find out how to make it work ?

yes, it works clicking on redligth inputs but now the problem is that the sound sometimes comedown for a miliseconds with a very small cut on the mix, on windows FS2 works better than this. Can i do something like increase the latency or similar? thank you for all

yes you can increase latency in the "Preferences / Audio" panel : Buffer size option