Page 1 of 1
no output signal
Posted:
18 Mar 2009, 22:08by wannes951
i use a maya 44 soundcard and the newest DVS software, but once the soundcard do not give an output signal on output 2, very strange, if i change my cd players the problem remains, so i think the soundcard is broken down or is there a solution?
Re: no output signal
Posted:
19 Mar 2009, 00:23by gakto2009
can you publish a config report for us please.
regards,
Bryan
Re: no output signal
Posted:
19 Mar 2009, 17:41by wannes951
this is when my cd players are both playing
Re: no output signal
Posted:
19 Mar 2009, 19:37by gakto2009
Do both the left and right players come from the left chanel?
Re: no output signal
Posted:
19 Mar 2009, 20:26by wannes951
no, I had connected cd player 1 on input 1 and 2 and cd player 2 on input 3 and 4. and the outputs are connected to my mixer, but when i play the cd players, on input 1 and 2 is there an output signal, on input 3 and 4 not. but the led's on input 3 and 4 are burning, so maybe the card is brokendown?
Re: no output signal
Posted:
20 Mar 2009, 06:31by UncleVibes
Vinyl1 connected=CD
Audio=ASIO source=0:IN 0 - MAYA44 USB-IN 1 - MAYA44 USB
Mode=absolute
Riaa=No Preamp Left=0 db Preamp Right=0 db Noise Filter=0 Hz
45T=No InverseLR=No PhaseInv=No
Decalage=0 ms Time limit=720000 ms
Silence seuil=-40.000 db SNR=40 db
Vinyl2 connected=CD
Audio=ASIO source=0:IN 0 - MAYA44 USB-IN 1 - MAYA44 USBMode=absolute
Riaa=No Preamp Left=0 db Preamp Right=0 db Noise Filter=0 Hz
45T=No InverseLR=No PhaseInv=No
Decalage=0 ms Time limit=720000 ms
Silence seuil=-40.000 db SNR=40 db
You use the same source for your right deck & for the left deck so it's normal you can't get the signal through. Just go in the vinyl option & select your right source & click on apply. It should work now.