Page 1 of 1
VCI-100 upgraded - less ability to backspin in MVP7
Posted:
15 Nov 2008, 04:55by bzbatl
I just upgraded my VCI-100 firmware to 1.2 and now I have no ability to do a back spin. Spinning the platters quickly simply moves the track as if I were doing a baby scratch (back fairly slowly)
Any ideas? I updated the MIDI file to the 1.2 one available in the downloads section.
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
16 Nov 2008, 06:15by bzbatl
Minor update, I've now tried this on two separate computers, and the same exact issue is occurring. I have multiple issues at this point:
1. Scratching is almost impossible, the jog wheels simply do not move the track much.
2. Backspins are completely impossible, no matter how fast I spin the wheels.
3. With vinyl mode off, the jog wheels jump around instead of smoothing moving through the track. Makes it hard to fine adjust cue points.
Is this just an issue with *my* upgrade? It seems to be sending the proper MIDI codes...
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
16 Nov 2008, 09:43by TuXxL
Hello
With some versions of MV, there are 2 versions of the MIDI file for the VCI.
Wich version do you use ?
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
16 Nov 2008, 09:44by bzbatl
I'm using the 1.2 MIDI file from the downloads area.
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
17 Nov 2008, 12:47by N-deep
Which software version do you use? Is it 7.1?
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
17 Nov 2008, 15:52by bzbatl
Yes, 7.100
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
17 Nov 2008, 16:17by N-deep
Thank you. djegun will check this and let you know.
Re: VCI-100 upgraded - less ability to backspin in MVP7
Posted:
21 Nov 2008, 23:44by dj tribalistic
i have the same problem too!!!
backspin and scratch are impossible due to a problem with MV7
it was better with MV 6.39
N-Deep any idea or feedback to the support team please