Help U46 mk2

[sandyman]

I have tested the routing with the demo version and it work for me :
- uninstall your drivers 1.041 properly : disconnect the soundcard THEN remove software.
- install the 3.0 (you will find them into the download center/drivers section (right pane here)
- check that you can use the U46 control panel
If you can then it's ok, go into what you know and set as you would like (worked for me).

But a the end I didn't have any sounds, I guess the asio mode is not available in the demo version.

On a side note 1&2/3&4/5&5 don't interfere with each other, only the mix out will give you all the outputs on the same channel.

Thank you as well. :-)

I must say I'm very pleased with the feedback I've been getting on this forum.

Cheers,
Sander

[Blackbrook]

I must say I'm very pleased with the feedback I've been getting on this forum.

Glad to hear that! Once I needed help Support@Mixvibes, sylMV and different others helped me out of it and now I am trying to give something back by helping others. Not always easy but worth if you can help a desperate user.

Greetings,

Steve

[Support@MixVibes]

Sorry I didn't see the chapter about Cross LE.
It will use the asio and you could test any outputs from any player, your issue is a bad driver for now.

[sandyman]

Good news!

I have reinstalled everything (including the cables) just to be sure and now everything is working fine.

I'm a happy camper now!

Thanks for all for your support. It's greatly appreciated!

Cheers,
Sander

[Blackbrook]

Good news!

I have reinstalled everything (including the cables) just to be sure and now everything is working fine.

I'm a happy camper now!

For all for your support. It's greatly appreciated!

Cheers,
Sander

Glad to hear! Have fun with it Sander!!!!!

Greetings,

Steve