Mixvibes doesn't work after Restart

[gakto2009]

it very well could be, though i have never used the U46MKII with the 1.0.35 version driver, nor have i used the U46MKII with anything other than Windows Vista and Windows 7.

Hope it works for you though.

[gakto2009]

Just to confirm, you are using 32 bit (x86) version of windows yes?

[BecksPin]

yes i do ;-)

[smaks]

I actually had the same problem,

nlite version of xp
u46 driver from original cd
update 7.1 of mixvibes,

it just disapeared after a few try's , sorry if this doent help you but that s what it has done to me.

[laurens]

I'm using the v1.041 driver. Previous month i have also installed patch 7.2... which i have downloaded from this site, but this patch isn't available anymore for some reason , the only thing i find now is the release candidate for patch 7.21.

[gakto2009]

I'm using the v1.041 driver. Previous month i have also installed patch 7.2... which i have downloaded from this site, but this patch isn't available anymore for some reason , the only thing i find now is the release candidate for patch 7.21.

RC versions of Mixvibes are for testing only, it is no recommended that you use them for public performance or any situations where stability is paramount.

7.200 was taken down due to some minor bugs that were found after its release, as a result version 7.100 was returned to official update status.

[BecksPin]

mmh installed the new driver...
works but didn't solve my problem...
but its ok...
i'm happy that it works anyway

[smaks]

answer to your PM,

My problem was that after an install everything worked fine,
once i closed MV and reopened it i had had to redo the configuration to recognise the signal that comes from my turntables,

once i had done that i would close MV and apply changes made, reopen it and i had to redo it all over again ,

after the third time i did this or something like that the settings were stored and everything was ok ,

[BecksPin]

ok...
so i hope it will get better after a few times ;-)
thx mate