DVS U-MIX44 dosen't recognize Stanton T92

[Support@MixVibes]

I insist, the problem is in something that has to do connection with the shown bars on the right of out/in devices.
Take a look, when media player is playing, there's a green signal showing that sound-card is playing sound, when I put the control vinyl playing to calibrate the player, there's a signal shown by orange led in U-MiX44 INPUT 1/2 but in Windows there's nothing showing that line-in is receiving signal.

in this link http://mixvibes.com/support/?p=815&lang=en there's line-in "bars", in my windows there's not.

This only show that your inputs aren't seen, so that your device isn't correctly installed.

If I install Asio4all I can correct this problem but the DVS still can't calibrate the player properly.

You think it is corrected, but the fact that it still doesn't work in DVS prove you're wrong.

look too for what I'm saying about Windows...
Windows Caption=No Theme=0

This is related to the ability of moving wndows arround in DVS.

Please read older posts.

A simple yes or no would have been enough

[eskillo]

I've formatted my disk, I've windows Ultimate and the problem still exists !

Everything is OK but on install wizard when I choose the vinyl and put the turntable playing, I click next, and nothing.... the time code is on zero...and the player is not calibrated successfully.

What can be this time ?

Regards, André .

[Support@MixVibes]

As I told you, the soundcard is not correctly installed.
Here is what I have :

The U-Mix isn't in the system :

No_Umix44_vista.JPG

With the U-Mix attached

with_umix44_vista.JPG

And this what windows is showing :

drivers_umix44.JPG

At this stage I didn't launch/open install anything from the MV cd, the driver are provided by Windows itself.

After this you install DVS and the asio drivers.