MIXVIBES Dj Community old forum

Hi,
The cuts for the dedicated hi/lo filters (and ESPECIALLY the HPF) aren't nearly as steep as for this in the Effects module, which makes them pretty well useless for filter mixing. These should filter in the same range as the equivalent HPF/LPF in the effects module. It would make them a lot more useful.

I see that the delay effect is locked to 1/2 beat. It would be very useful if for this and other beat effects we could use them the same way you use them on a DJM (1/4,/1/2,3/4, etc.)

The new filters on 3.1.0 RC are a great improvement over the old ones, however I'd also like a full filter 'kill' as this is the usual behavior on various hard- and software.

discopex wrote: however I'd also like a full filter 'kill' as this is the usual behavior on various hard- and software.

As in 3.1 RC...

sylMV wrote:

discopex wrote: however I'd also like a full filter 'kill' as this is the usual behavior on various hard- and software.

As in 3.1 RC...

Not a full LP/HP kill here, just tested again?!

discopex wrote:

sylMV wrote:

discopex wrote: however I'd also like a full filter 'kill' as this is the usual behavior on various hard- and software.

As in 3.1 RC...

Not a full LP/HP kill here, just tested again?!

3.1 features full kills for sure.

I get kills with EQ only but not the bi-filter, tested with internal/simple stereo.

discopex wrote:I get kills with EQ only but not the bi-filter, tested with internal/simple stereo.

When using it on the low pass (resp. hi pass) side, trebles (resp. bass) get killed.
Don't get what you mean then.

I'm talking full filter kill (mute) when in the extreme position. This behaviour makes for handier 'filter mixing' so you don't need to use additional eq or crossfader/line fader at all.

discopex wrote:I'm talking full filter kill (mute) when in the extreme position. This behaviour makes for handier 'filter mixing' so you don't need to use additional eq or crossfader/line fader at all.

How the bi-filter could be useful it it killed at the extreme positions?
!?
That's definitely not its purpose..

discopex wrote:I'm talking full filter kill (mute) when in the extreme position. This behaviour makes for handier 'filter mixing' so you don't need to use additional eq or crossfader/line fader at all.

So you want the filter to operate as follows:
Filter set to extreme left- Passes all Low frequencies and kills Hi.
Filter set to middle-- Passes all frequencies
Filter set to extreme right-- Passes all Hi frequencies and kills Lows.

Not that I can provide the solution but I find the conversation interesting so I am just trying to understand your entry.