Mixvibes Dj Community old forum

Hi, since yesterday i update to Cross4. I use a Pioneer SB2 and a AKAI MPD218. Everything is ok with the SB2 but not with the AKAI. In Cross 3 i use the AKAI for the Filters and Effects. In Cross4 it is not possible. I create a new controller in the list and teach the knobs and pads in MIDI section. If i teach a knob for the FX (Filter Delay for example), the line from the knob turns a little bit and stay after few seconds in only one position. I could turn the knob on the AKAI and see that somthing happend at Cross but it is not the full range of the filter, only one position or the line tremble...
Via MIDI learn, is the same.


I hope you could help me! Best regards, Sven