by ashp on 15 Jun 2019, 18:45
Dear Mixvibes Community,
This controller needs special programing to hande the PAD mode switching as this is not implemented in firmware is it possible to handle the LED's for which pad mode is selected and also need to implement a double press for the second mode like how this controller is setup in serato is this possible to program into the software
five Pad Modes:-
CUES
AUTOLOOP
MANUAL LOOP
SLICER
SAMPLER
Double press pad modes: -
TRANSPORT
LOOP ROLL
FLIP this could be ignored for now!
SLICER LOOP
VELOCITY SLICER,
also need a way to implement the deck switch 1/3 and 2/4
also looking for a way to send MIDI signal for loop size
Kind Regards,
ashp