Mixvibes Dj Community old forum

Hello. i just bougth it. Had problems with USB 3.0, But it's possible to turn it off in BIOS. At first My controler lose connection from time to time, is there any reason ? And my main question is..
Why i can't scratch with software fader.. it react reallly slow.

Most controllers are USB 1.1 as there is no advantage in using higher speed. Wheb using a usb 3 host it can be that 1.1 support isn;t activated by default.

A workaroubd could be to use a (powered) usb 2 hub.

Disconnection can have to do with powersaving settings or insufficient powersupply by the host (to many devices connected?)

Hi djdejf,

If recommendations from RoJeC don't seem to solve the issue, it might be something as simple as a faulty USB cable. So try swapping that out as well.

Also when you are trying to scratch with the software crossfader is the movement on screen slow or is it that the fader curve is not set sharp enough for scratching?

You can adjust the curve in the settings for Cross DJ (this is a shot of Cross so it may look a little different):

Notice that the fader bar underneath where it says "Custom" is filled orange or all the way to the left. That is how you will want the crossfader set for the sharpest possible curve.

Regards,
Adam @Mixvibes

Thanks Mr. Adam ;-) I will try on older-generation notebook.. USB 3.1 is now standard. My device was designed for 1.1 (propably). Now i can only fight with disconnects and crazy crossfader....
https://www.instagram.com/p/Bjk3B5IHBVE/