Re: Need a pitch fader for U-Mix Control Pro
Posted: 07 Jun 2017, 21:28Perhaps the technician can tell you what unit measurement that label means. I spent couple hours researching sources and only found references to volume, pressure, and an actual electronic manufacturer's name but nothing related to in circuit electronics.
As a suggestion, if the fader doesn't cost too much.
You install the replacement and probably find the following conditions:
1. it doesn't work.
back to the drawing board.
2. it work perfectly
you are done.
3. it works but the response is different than the other original fader.
replace the other original fader in order to have both of them respond equally.
As a suggestion, if the fader doesn't cost too much.
You install the replacement and probably find the following conditions:
1. it doesn't work.
back to the drawing board.
2. it work perfectly
you are done.
3. it works but the response is different than the other original fader.
replace the other original fader in order to have both of them respond equally.
maybe the Pioneer fourm /support/techinial services would have the answer ,,