MIXVIBES Dj Community old forum

Here is what i found

- Load a track
- Store a loop ,in example, at 30 sec of the track
- Store a loop in 40 sec of the track

Start track from the beggining and enable store loop 1.
You will see that Cross overtakes loop 1 and enables the second loop. Loading track again does exacly the same.
You have to enable the first loop by pushing the locator and then loop 1 will be active.

Stelios, Greece

sfronti wrote:Here is what i found

- Load a track
- Store a loop ,in example, at 30 sec of the track
- Store a loop in 40 sec of the track

Start track from the beggining and enable store loop 1.

How do you do that ?
If you click on the loop/locator 1 it will jump directly.
If you click on the loop on/off button you will switch/on the last loop setted, in our case it will be loop/locator 2.

Don't push and select the locator, just push the button to activate the loop when time comes.I'll sent a video.

Stelios, Greece

Video seen, when you do the on/off, in fact it is on the last active loop.
So in your video, the last active was the loop 1, so you will always retrigg the loop#1 with the on/off.

Another loop based question, not trying to hijack this thread...

Can you alter loop length (halve/double) via MIDI when loop is not playing? is this some other setting or what. I can only alter loop length when inside a playing loop. I just want to change the default loop, I know I can do this with the mouse.

Yes, you can.

Offtopic.HorsSujet!

not trying to hijack, doesn´t make it any better btw

Support@MixVibes wrote:Video seen, when you do the on/off, in fact it is on the last active loop.
So in your video, the last active was the loop 1, so you will always retrigg the loop#1 with the on/off.

Yes but the "proper" behaviour is when the time of loop 1 passes when i push the on/off, loop 2 should be active when the time comes.

Stelios, Greece

sfronti wrote:Yes but the "proper" behaviour is when the time of loop 1 passes when i push the on/off, loop 2 should be active when the time comes.

Cross never worked like that. The on/off is related to the last used/saved loop.

How about loop double/halve via MIDI controller while not in loop mode? for some reason the same buttons (that I mapped) that do work when the loop is playing but do nothing when off the loop mode. I can only change the length with mouse.

It is still the same : related to the active loop.
How the software would know what loop you want to resize when they're all off ?