MIXVIBES Dj Community old forum

Hi, i have installed an incorrect firmware in my U-Mix Control Pro 2 "firmware 4.2" where it was installed by mistake. The device is flashing both Source A and B. Kindly advise if I can reset the device or install the correct firmware again.

not familiar with firmware issues with control pro 2 yet,, first off please regerster on the fourm your software licence key in user control panel/profile ,, that way you have access to all of the avaible fourm pages ,ie download section , if need be to get the right firmware for your controller again welcome to mixvibes

You tried to flash a UMCP2 with a U-Mix Control Pro firmware ?


Why did you try to update the firmware ?

You are correct i flashed a UMCP2 with a U-Mix Control Pro firmware. after completing the installation of the UMCP2 software, it mentioned that i have to do an update. I didn't see the note posted "not for U-Mix Control Pro 2".

You were told to update the software, not the firmware of the controller... And in any case, for the next time, double check the name of the device for which the firmware is made!

Anyway, a solution will be found soon.

Cheers,

You should now have received an email with the correct file.

Thanks for all your support, all is well and the device is working. Next time I will double check the device with the correct firmware provided.

Check a posting for the control pro 2 MIDI mapping correction, unable to post a link from this computer,,,,and welcome to the fourm ,,any can or tried to be answered.

viewtopic.php?f=354&t=25826
heres the link,,,read and understand before proceeding

Great Job Support and Sylvain!!!!