Mixvibes Dj Community old forum

Hi, just bought myself a Mixvibes U-Mix Control Pro and would like to try out CrossDJ 2, but i cant find a download for it anywhere?

I have issues with sound in my headphones as well, but this works fine with Traktor so it is not the controler that is bad. I cant find out what the problem is in CrossDJ, and I am hoping that an updated version will work.

Please help.

Thanks, Cheers!

You need to access to your profile and place there your softwarre key. It will open download center doors (and free support)

Thanks UncleVibes, so now i got the CrossDJ 2, but i still have the problem of not getting sound in my headphones

My setup is simple, and should be simple to set up in the software:

- I have a mac with the U-Mix Control Pro connected via USB.
- I Connect a phono to my U-Mix output 1/2 and to my stereo reciever.
- I choose MixVibes U-Mix as my core audio device in Cross DJ
- I set Output 1 to "Output 1/Output 2.
- Routing mode: Dual stereo.

What am i doing wrong, going nuts... In Traktor i have no issues..

inverse your audio output 3/4 instead of 1/2

if you are trying to connect a turntable to run timecode vinal for control you will need the full ver of Cross to run time code,,,,Cross DJ is only MIDI controlable

froz wrote:inverse your audio output 3/4 instead of 1/2

I have tried, doesent work, i either get both "records" playing out loud on the speakers or just in my headphones...

daniel clark wrote::cool: if you are trying to connect a turntable to run timecode vial for control you will need the full ver of Cross to run time code,,,,CrossDJ is only MIDI controlable

I only have the U-Mux Control Pro. No turntables or extra stuff..

rubys wrote:Thanks UncleVibes, so now i got the CrossDJ 2, but i still have the problem of not getting sound in my headphones

My setup is simple, and should be simple to set up in the software:

-
- I Connect a phono to my U-Mix output 1/2 and to my stereo reciever.
-
- I set Output 1 to "Output 1/Output 2.
- Routing mode: Dual stereo.

What am i doing wrong, going nuts... In Traktor i have no issues..

you would connect the phono to input 1/2

you would connect output 1/2 to your sound amplifier

please check the set up manual for all the info you might need

heres a link
http://www.mixvibes.com/sites/default/f ... nual_0.pdf

Please install and use the asio drivers of the U-Mix Control Pro.
Then apply the settings from the manual.

You can also post your audio configuration screen from CrossDJ for checking.