--Solved-- U-Mix Control Pro audio setup

[Hannes]

Cue.PNG

do you have the cue-mix dial set up like this?
and is the fader down for the cue´d track?

(might look different on crossdj, took the pic from Cross)

[gman]

on the front edge on controller pro, I have

MIX LEVELS head phone connect
knob knob
CUE MASTER zero -- max

if I turn MIX knob to CUE 100% system music cuts off
to MASTER 100%
center system music on

hold down CUE
with headphone button highlighted

both tracks play on system speakers.

I have CUEd track fader down
left right fader in center
even with left right fader to left SOURCE A they both play if
CUE is held down

[gman]

I have two system speakers hooked up.

I have output cables connected to 3/4

is this correct?

I have tried other variations, but, I still did not find the correct
settings.

[gman]

I think I have it.

I moved both outputs to 3 / 4 and seems to be working..

[Hannes]

Speakers go to 1/2, headphones connect in the front.

If you press cue, only this track should play in the headphones if the mix-cue is set to zero. The more you turn the mix-cue the more you will hear the song that plays over the speakers.

[daniel clark]

audio routing mode dual stero ,
the outputs from the controller 1 &2 should connect to your system speakers ,
the headphone jack will hear the outputs of the cue section if the routing is set for channel 3&4,
the headphone buttons can be controled by the controller or by the gui,
if you have either player headphone hightligghted they will play thru the headphones,
you have to un hightlight the heaphone cue from the player you dont want to hear ,
the master mix knob on the front should work as j cut sescribed .
if you look on the product page under U-Mix Control and go to doccuments ther is a larger easier to read set up manual which goes thru all of this with pictures of different set ups and very detailed info as to setting it up properly
welcome to mixvibes and U-Mix Control Pro

[gman]

I tried with output jack connected to 1/2 , but, the CUE to headphones did not work.

I moved the output connections to 3/4 and the headphones CUE
as they should.

I can now play track A and listen to track B with the head phone button highlighted.

All sounds good and works as I expect.

I know this does not follow what daniel clark is pointing out, but, it is working.


Thank you all for the help.

[Support@MixVibes]

It is because you have reversed the 2 first line :
Output 1 = 3&4
Output 2 = 1&2

instead of :
Output 1 = 1&2
Output 2 = 3&4

[Doctorm]

Had the same problem as you mate, was like 1 hour trying to get it work but then i saw on my Cross DJ program that the knob on the right side of the MIX/VOL knob was tured down to 0

[Support@MixVibes]

Cue volume : headphones
Cue mix : rate of each into the headphones
Master volume : speakers