MIXVIBES Dj Community old forum

Yep. Bought another controller
Imported the mapping to Cross. Fine.

What i want to do:
- Control the Cross decks via MIDI and vinyl timecode.

I would like to know what config i have to use @ the audio config.
External Mixer?

TIA!

dual stereo should work, you only need to configure the inputs.

external mixer only if the controller can work as a stand-alone mixer as well.

Offtopic.HorsSujet!

hättest auch im dt forum schreiben können, auch wenn dort einer rumtrollt

Thanks, works! However i had to disable 14-Bit MIDI support to make both faders work.

So timecode is fine.
But the jog`s doesn`t work when i move them. No response into the software but i can see that it is sending MIDI.

PFL-LED meters (Jockey ones) even not working. Wahhhh...

i guess the jogs are blocked by the timecode
not shure bout the leds, did they work for midi-only?

edit: what faders? channel or pitch?

J-Kut you re my man hehe.
Okay, i need to switch the vinyl inputs off to get the jogs work.
But no LED`s on the hardware flashing. Even not into MIDI only mode.

Edit as well: When 14-Bit (which is supported by the device) is active the left channel fader does not work (all other controls do).

if the jockey 3 works as a mixer as well, you could try the external mixer setting and see how it does. might solve the led issue.

(midi-out is ticked in Cross?)

did you try remapping the fader?

Offtopic.HorsSujet!

i´m off for bed now, see ya tomorrow

Will check that out tomorrow.
Have a good night, bud!

Hey,
tried it this morning since i was up early

No LED-PFLs at all.
External Mixer mode doesn`t work since the unit does not support it. It`s "stand-alone" mixer feature is just for the external inputs.
"MIDI-out" is ticked of course.

Maybe i should just try to remove the mapping and import it again?
Will try that when i`m back to home.

try

THX!
Will do when i`m back home!