by gillies2001 on 21 Dec 2014, 03:44
Hi Guys, im having an issue where every time I open Cross I need to tweak EVERY knob and fader on my vci-400 pass the point of the software value before responds. Once its been done everything is fine untill I have to open the program again, I know its not the biggest issue but the VCI-400 has a tone of knobs and its getting very tiring!
side note* this also has to be done even if the hardware and software values match on open, example - If I open Cross & filter 'A' is set to 12 o'clock on both the hardware AND software, I will still need to move the filter knob (on the hardware) off 12 o'clock than back to 12 before it will communicate with Cross.
I know when mapping in Traktor there is a Hardware/Software 'Takeover' option that prevents this issue, does Cross have one hidden somewhere???
Thanks guys