by Team@Mixvibes on 23 Jun 2018, 01:22
Hi neymarjr!
This should be possible since Cross DJ has an option to send the DVS input directly to the software (I think it was specifically designed for this purpose). The command is called "Input Mode" and can be found in the Mixer section of the MIDI/Key map page. There will be one Input mode command for each possible deck (A,B,C,D in Cross, I believe with Cross LE there will only be 2).
Anyway, this command disables the deck in Cross and will route the incoming DVS signal directly to the corresponding mixer channel, allowing you to play vinyl through Cross and use the built in FX (these might not work the best since the BPM info will be unknown by Cross)
Let me know if you end up going this route and need help getting things setup!
All the best,
Adam @Mixvibes
For support requests, you can check out the FAQ and reach our support staff at
this page.Thank You!
Team@MixVibes gives no support on the forums including via PM