sfronti wrote:I have a G4V from Gemini and i have the same problem. I made a basic mapping but i can not make the buttons to light up.
Stelios, Greece
I looked at your map. The reason why you can't get the LEDs to light up is because you are using modshiftlogic command as togglers. When you used modshiftlogic commands as togglers you must map the LED for every condition possible.
Example
If you have ML1 and ML2
and you one a certain led to be functional all the time
then you must map as follow
LED on
LED off
LED on ML1 Active
LED off ML1 Active
LED on ML2 Active
LED off ML2 Active
LED on ML1 and ML2 Active
LED off ML1 and ML2 Active
the number of conditions squared = the number of possible conditions
n to the second power
(n to the second power) times 2 accounts for the 2 led conditions
on and off
in my example 2 conditions
2 conditions squared=4
(2 conditions squared)X2=# of maps per LED=4X2 =8
for every 2 conditions use you must square the number of condition
I will look at the documents that you sent and see what I can do.