MIXVIBES Dj Community old forum

I have a xone 23c and the full version of Cross. I made the internal modification per page 19 and had successfully ran DVS about a month ago but I haven't been able to get timecode to work since. I think the issue is the wiring job, maybe it came lose since I put away the mixer before my vacation. I think this because under the audio tab I two outputs (output 1: output1/2 ouput 2: output3/4), however I only have one input (input 1: input1/2). I am pretty sure input 2 should be (input 2: input3/4) I can send audio from my computer to the mixer to the speakers, and I have no trouble sending a vinyl signal from the tt to the mixer to the speakers. Any help is appreciated.

Do you have the latest version of Cross installed. Check Downloads (menu at right of posts).

Figured it out. The reason I couldn't send sound from the mixer to the computer was because choosing xone23c under 'core audio' in the audio tab in Cross doesn't automatically convert all inputs/outputs to said device. The problem was under my mac book system preferences: under 'sound' my output was set to xone23c however my input was set to the internal microphone on my laptop. Odd quirk!