MIXVIBES Dj Community old forum

I have lost my usb power cable for my mix vibes pro 2 (I think that's what it's called) and I was wondering if there is anywhere I can buy a new one or one for the 6v slot, I'm from the UK

http://www.amazon.co.uk/AMOS-Universal- ... er+adapter

Would this work?

iiGeesus wrote:I have lost my usb power cable for my mix vibes pro 2 (I think that's what it's called) and I was wondering if there is anywhere I can buy a new one or one for the 6v slot, I'm from the UK

The link you supplied is for a power adaptor ,,multi use/multi voltage ,, briefly look at if the voltages and ampregage is the same, it should work ,, didn't see if the polarity is reversible ,, ,, that's if that what you are looking for and not the usb cable that sends /receives the siginal to/from the computer/software ,, this also powers up the unit as well ,,,hope this helps ,,
will delete the duplicate posting at a later date ,

As Daniel pointed out, you need two cables if you are to power and send digital signal separately.

You need a USB to send digital signals from the computer to the U-Mix Control Pro.
You also need a power supply.

You can do both just using a USB but as mentioned if you want to go separate then you need two cables.

The unit that you are looking at will work for power as long as you select the 6V output.

Oh and it does have a reversed polarity switch so it is all good.

Hmm, well do either of you know where I can buy a usb 6v barrel connector? Would be a lot better if I could just buy a replacement usb power cable though.

the usb cable is a standard usb cable for a printer ,, not shure what the name for the conector is,,how are you using the controller

I'm not using the controller because I don't have a power cable for it ^^

go to what ever local supplier of computer products and get a usb cable with the proper end for the controller

I found one, thanks for the help guys.