Cant Setup my Mixvibes Ultimate DVS???

[lovejones]

Good Morning,

i just bought Mixvibes Ultimate DVS off ebay 2 days ago, but I still cant get it to work. I`ve raed nearly everything i found on the internet, but still nothing. I really cant figure out where the problem is, so I´ll try to explain to you how I did set mixvibes up.

I connect the outs (cinch) and Ground from my turntable to the Input 1 from my U-Mix and the ground to the U-Mix.
( Is there a problem that i dont use a DJ mixer? Back in the days I used to work with m-audio torq, and there wasnt a problem???)

Then I connect the output 1 from the U-Mix directly to the MPC 2000 inputs.
(Here again, the mpc dont` get no inputs. Maybe it`s a problem that the inputs of the MPC are 6,3mm Klinke and no cinch???
The thing is if i plug the audio outs of my U-Mix directly into my studio monitors i cant here a sound)

Then I did setup the audio in windows. For recording i choose the mixbives sound device. For Playback i also did choose the mixvibes sound device.

Here again a problem. When I try to play a timecode vinyl, the U-Mix can only pick up a very weak signal, so that i cant`configure my turntables when i use the install wizard.

What i else noticed is that when i play timecode vinyls, i can hear a lot noise of my turntables, which is probably the timecode signal. Is it normal that u hear this noise coming of the vinyl???


I Know, many questions, but im absolutely clueless what I´m doing wrong.

Would be so kind if anyone could help me.

[RoJeC]

Have little knowledge; from reading other info I'll try to give some general direction. Might help more knowledgeble users to help you better.
Try connecting turntable by line if supported by tt. Make sure all switches are on line (or phono if needed)
I think you need to disabled audio inputs in settings.

An external mixer is not needed; Cross has mixer unless you select extenal mixer mode for audio routing.

Different connectors should generally not be an issue; only different shape. With Cinch you just know it is mono. With Jack there always can be a 'hidden' problem as it can stereo or balanced mono if there is a ring on the male and/or female part of the connection.

[christiankoopmann]

Hey,

if you are running DVS could you please post a config file?
Go at the Menu->preferences->generate Config

After creating the file please post it here and than we can see how you configured your System.
Also describe more detailed how your Setup is (System, Notebook and so on and how it is connected).

regards
Christian

[lovejones]

Everything works fine. Thank you for your support

[daniel clark]

post any info as to a solution and will move to approiate topic page as resolved ,, glad you got it sorted out ,