MIXVIBES Dj Community old forum

hi! (sry my english) i lose my U-Mix Control Pro cd drives, and now i can't instal the drives on my mac, im new user from mac, i already download,install the drives from here, i open it, i see 2 eq " input level, output level, both bottoms are down and i can't up it, when i did this mensagem come.

"unable to control input leve. please use the mac osx control. in [audio MIDI setup], select U-Mix Control Pro in [propries for:] and the [audio input section,"

o kay ,, ,,did you try what the message suggest
not familiar with mac o s and if you downloaded drivers from the website or from your cd install disk
if it was from the cd install disk ,, should be on it ,,
if drivers are needed from the fourm ,, then the first thing nessary is to regerster your software licence key on the fourm,,user control panel/profile//serial #,, once regerstered you will have access to the download section of the fourm ,, where updates and drivers and firm ware are located ,,not shure as to the full solution but regerstering is a start ..,
welcome .. and the licence key is on the cd install sleeve ,, hope you didnt discard it .

yes i got it already, i lost my cd instal :/ i already instal drives from forum but my mac don't know the mix vibes, i download that control panel U-Mix vibes control, instal it and open, and when i try to turn the eq on, this message come ""unable to control input leve. please use the Mac osx control. in [audio MIDI setup], select U-Mix Control Pro in [propries for:] and the [audio input section," and can't turn it on "muted off", on my PC i can and its ok :s can u help me plz

what's the driver + firmware version you downloaded?

"mix vibes U-Mix Control volume panel 1.0.5" is it correct i think, if i install another one, it say "no device plugged" and when i open this "1.0.5" device apparently on, but when i try to put output on, this mensagem come again "unable to control input leve. please use the Mac osx control. in [audio MIDI setup], select U-Mix Control Pro in [propries for:] and the [audio input section," (
firmware i already tried the both, but now i got U-Mix Control Pro firmware 4.2

look here whats happening
[img]http://postimg.org/image/oh2gu5ztx//img]

look here whats happening

Sorry can't help you. You'll have to wait for someone with more Mac knowledge. Don't recall to have seen this issue; unless it was reorted in other language...

bahh :/ ok, maybe U-Mix Control is not compatible with mac..

the Mac driver is compatible with Mac...