MIXVIBES Dj Community old forum

i have a Numark IDJ3, I purchased Cross DJ 2.5 for I am unable to map the controller so that headphones and master volume work. perhaps someone can help me.

First of all please enter your Cross serial into your Profile (User Control Panel > Profile)

ucp.php?i=169

By doing this, it should allow you to download the latest version of CrossDJ, 2.6.0 from your Download Centre

downloads.php?cat=54

Going back to your original problem. Have you installed the special MixVibes Firmware for the controller? In not it can be found on here

http://www.Numark.com/product/idj3

Check the Download header on the right hand side of the page

I have the same problem.
Purchased CrossDJ-software and installed it.
Updated to version 2.6.
The software is running on Vista 32-bit, and the PC is an Acer TravelMate 7350.
Tried to install the firmware for MixVibes from Numark but there is an time-out-error during installation.
I can run the iDJ3 with MixVibes/CrossDJ-software, but can't get the sound out to the headphones nor can I adjust the volume of headphones and master from the controller.

Annoying!!

please put the licence key in your profile user control panel/profile/serial # ..