Mapping for Idj3

[Daphresh]

i have a Numark IDJ3, I purchased Cross DJ 2.5 for I am unable to map the controller so that headphones and master volume work. perhaps someone can help me.

[Jim B]

First of all please enter your Cross serial into your Profile (User Control Panel > Profile)

ucp.php?i=169

By doing this, it should allow you to download the latest version of CrossDJ, 2.6.0 from your Download Centre

downloads.php?cat=54

Going back to your original problem. Have you installed the special MixVibes Firmware for the controller? In not it can be found on here

http://www.Numark.com/product/idj3

Check the Download header on the right hand side of the page

[olledahl]

I have the same problem.
Purchased CrossDJ-software and installed it.
Updated to version 2.6.
The software is running on Vista 32-bit, and the PC is an Acer TravelMate 7350.
Tried to install the firmware for MixVibes from Numark but there is an time-out-error during installation.
I can run the iDJ3 with MixVibes/CrossDJ-software, but can't get the sound out to the headphones nor can I adjust the volume of headphones and master from the controller.

Annoying!!

[daniel clark]

please put the licence key in your profile user control panel/profile/serial # ..