MIXVIBES Dj Community old forum

Sorry if this has been discussed, but is there any way to use the SL one Box to work with Cross DJ?

Thanks!

Not sure what that is? Can you give us more information?

We'll surely help if we can!

Is there any way to use the Serato Scratch Live BOX 1 to work with CrossDJ?

you are looking for someone who has used the sl1 with Cross ,,, untill someone that has personel experience with this and can offer some info ,, give us who are not familiar with it some info so we can help you figure it out ,, the support staff comes on in the am freanch time and probly can confirm or reject the possibilities untill then a link to the sl1 and spec might help

yes ..the serato sl1 & sl2 audio interface works with Cross ..

you need the ASIO drivers from serato 2.2 ....dont get the 2.4 ASIO DRIVERS as that are buggy

Does they now allow more than 1 pair of inputs and one pair of outputs ?

yes, you can actually use the SL1 for timecode with Cross, but the latency sucks...it´s set to a fix 10ms.

I dunno if it´s really 10ms Buffer, or if they calculate and show the rtl
but it really sucks imo, feels like scratching on rubber...
Of course the SSL-driver feels tight

Support@MixVibes wrote:Does they now allow more than 1 pair of inputs and one pair of outputs ?

yes I get 4 in's and 4 out's from my sl2 under ASIO & core audio

my Rane ttm57 serato mixer ....I only get 1 pair off in's and outs

j-kut is right ...It works ,but not good...

Thank You. That was the reply I was looking for.