MIXVIBES Dj Community old forum

echey wrote:Sure !!!!!!
I did look at:
Loop Halve
Loop Double
Where you only use two pads one for decrease and another for increase,

but that's not my way, I like to jump directly to any loop length, you know, use many pads...
About the effects, the same, by browser...

echey wrote:Sure !!!!!!
I did look at:
Loop Halve
Loop Double
Where you only use two pads one for decrease and another for increase,

but that's not my way, I like to jump directly to any loop length, you know, use many pads...
About the effects, the same, by browser...

I guess you find where you could activate slip mode in Cross 2.3 RC.
If not, hower your mouse onto one of the deck-waveforms, and top-left corner there you go.

How to map the loops: YOu can do it with keyboard.
Go to Preferences/ Keyboard.
If you don't have a third keyboard mapping listed there, click on one of them (PC Laptop one), and click the small [x2] button on the in the lower section on the window, which will create a duplicate version of the mapping, that you can modify.

On the right side in the list choose for example Player 1, and expand it. Than scroll down untill you find "Auto Loop Select and Trigger", and click on the little plus next to it.
Now it pops up a window. Press any keyboard key, you want to trigger and auto-loop. Then in the list choose "Direct integer Button", below that then input any value from the following list:

1 - 1/32 beat
2 - 1/16 beat
3 - 1/8 beat
4 - 1/4 beat
5 - 1/2
6 - 1 beat
7 - 2 beats
8 - 4 beats
9 - 8 beats
10 - 16 beats
11 - 32 beats
12 - 1/3 beats
13 - 3/4 beats

This also works with pads, I already tried it.

Support@MixVibes wrote:
Cinq : custom needs = custom work.